home
***
CD-ROM
|
disk
|
FTP
|
other
***
search
/
SuperHack
/
SuperHack CD.bin
/
SCRIPTZ
/
PHISH.ZIP
/
trumpet.txt
< prev
next >
Wrap
Text File
|
1997-04-03
|
2KB
|
46 lines
INSTALL TEXT FER TRUMPET WINSOCK 3.0 REVISION D
By Calimus
For starters...never install trumpet while u are on the internet.
If u have done this...u need to reinstall it again and let it overwrite
itself. If u have installed it and have changed the winsoc.old file back
to winsock.dll...please rename it winsock.old so that it will not interfear
with Trumpet. And if you just want to play safe...just reinstall it anyway.
Here are the thing's u will need to know for using trumpet with Netcom:
Leave the are called ip address blank.
1: The DNS server(s) is a list of ip's from the server. usually six
different ip's will do. Here is a list of ip's u can use for it:
199.182.120.1 199.182.120.2 199.182.120.202 199.182.120.203
Put a space between th ip's or it will not work!
2: The Domain Suffix is: ix.netcom.com
3: Make sure you select the PPP setting below Domain Suffix and not SLIP
4: Leave the Vector, Gateway, and Netmask as zero's
5: In Dialer Settings do the following: Make sure to select the ComPort
that you're modem is on. Then set the dialer for Hardware Handshaking.
Then select the correct Baud rate for you're modem. Then make sure of
the following setting that are also in Dialer Settings:
On Line Status Detection=NONE
AutoMatic Login=No Automatic Login
Parity and Word Size=Standard SLIP/PPP Settings
6: After finishing the setup go to the PPP Options...there you must set it
for: Use Pasword Authentication Protocol (PAP)
Then where it says Username make sure to put us,ppp,(U'r username)
And then enter you're password normally
7: You're setup is finished but you are not done...you must dial into
Netcom Manually or Trumpet will not work. To do this...Find the number
of ur netcom provider in dial-up. Dail-up can be found in the
accesories pop-up of windows95. When you start up Trumpet...go to the
Dialer menu and select Manual Login. You will see a blinking cursor
near the bottom of ur screen. At that cursor you must type
: atdt (Netcom's number). Make sure you add one space after the atdt command.
8: You're all ready now...Have fun